MENU

SEARCH

Handprinted
{module_shoppingcartsummary template="/ModuleTemplates/shoppingcart.tpl"}

FREE DELIVERY
on UK orders over £100

Our Blog

How to Design and Print a Half Drop Repeating Pattern

Tuesday, May 12, 2015

Following our last post 'How to Design and Print a Straight Repeating Pattern', here's the next step: how to create a half drop repeating pattern!

We have used the same motifs so you can see the difference.

Straight repeat: the elements of the pattern are lined up in a grid (see below)

Half drop repeat: the elements of the pattern are stepped (see below)

Start by drawing around your block. We are using MasterCut.

Draw part of your design in the centre of your template.

Cut out your template. Label the corners 1 - 4 and cut your template in half as seen below.

Swap over the two halves to looks like this:

Cut the right half in two horizontally.

Swap these two pieces so your numbered pieces are in the order pictured below. This step creates your half drop.

Hold (or tape on the back) your pieces together. Draw the rest of your design over the middle to fill the space.

When you are happy with your design, trace it with a soft pencil onto tracing paper and transfer it onto your block.

Use your lino tools to carve out the white areas of your block.

When it's fully carved, ink up your block using a VersaCraft fabric ink pad. We love these because they can be printed onto almost any surface and they're washable on fabric! Washable on fabric + less mess when printing = bliss.

Place your block in the top left corner of your fabric. An arrow on the back helps to make sure it's always up the right way. Press the back of the lock with the flat of your hand to print.

Place your next print directly below the first.

The next row needs to be placed half a block down from the first row. The top of our block matches up at the top of the large circle, where the design meets. This helps us to place our block.

Continue this row directly down from this point.

Continue printing in this way until all of your fabric is covered. For the top and bottom edges of your fabric, some prints will have to overlap the edge of the fabric. To get a neat edge, place a piece of scrap paper to mask off the area you don't want printed (ie the edges of your fabric or the kitchen table)

Our final half drop repeat pattern:

To block print a repeat pattern you will need:

Search Blogs


Recent Posts

Categories

Archive